Motorhome builds, upgrades, and tuning — project portfolio:

- Complete strip-out of the vehicle’s old interior fit-out.
- New layout design and selection of engineering solutions.
- Furniture built from moisture-resistant plywood.
- Sleeping berths fitted with quality mattresses.
- Fresh water and waste plumbing installed.
- Electrical systems inspected, updated, and modernised.
- Solar panels with charge controller.
- Additional passenger seat mounted in the cab.

- New sleeping-pod shape with a raised “hump” at the rear.
- Convenient access to all systems for servicing.
- Revised junction between the sleeping pod and the cab.
- Simpler, quicker procedure for removing and refitting the sleeping pod.
- New underslung storage boxes and fresh-water tank of our own design.
- New slide-out outdoor kitchen module on telescopic slides.
- Fold-down overhead berth structure simplified as far as possible.
- Large, sturdy awning with wall panels — our own design.
- New hopper window; new entry door with a fixed pane.
- New, easier ladder for entering the sleeping pod and reaching the roof.

- Two windows fitted in the rear barn doors.
- Power-operated sliding side door.
- Door cards retrimmed; flaws in the lining corrected.
- Roof rack and exterior lighting.
- All cabinet panels replaced with plywood.
- Overhead lockers and shelves built.
- New kitchen worktop and locks on the drawers.
- Dining table with quick-release mounting.
- Sleeping area reworked with increased bed height.
- Fill neck for the fresh water tank.
- Grey water tank revised; galley drain rerouted; push-button dump valve.

- Sleeping pod built into the factory flatbed.
- Underslung boxes mounted beneath the flatbed.
- Water, heating, and electrical systems — design and installation.
- Slide-out outdoor kitchen module with tie-down points.
- Flatbed sides painted to match the cab.
- Engine cooling system improvements.
- Bike rack selected and fitted.
- Chassis tuning and off-road preparation.

- Old Trekol cabin trim removed.
- New cabin built from moisture-resistant plywood and painted.
- Furniture and mounts for the required medical equipment.
- 12 V and 230 V electrical supply — design and installation.
- Medical examination lamps with cigarette-lighter sockets and IV hooks.
- Cabin and doors retrimmed.
- Rotating beacon fitted and wired.
- Tyre inflation compressor repaired.

- All soft furniture in the living area and cab seats retrimmed.
- New electrical distribution / control panel built.
- Full electrical and media system upgrade.
- House battery charging from the alternator while driving.
- Exterior hatch cut in for access to the storage bay.
- Roof hatch replaced and wired to an extractor fan.
- Broken camper window replaced with a higher-quality unit.
- Bike mounts fabricated for the roof rack.
- Major engine overhaul.

- Entire suspension reinforced and revised, including widening the rear track.
- Wall and ceiling lining around the sleeping berths for extra insulation.
- Load-bearing furniture structures replaced with moisture-resistant laminated plywood.
- Additional fresh-water tank fitted.
- Instant gas water heater installed and connected.
- All water hoses and mixers replaced; water supply system redesigned.
- Second cabin heater fitted with an extra diesel tank.
- Roof cargo box and access ladder built.
- New dining table with a more convenient lift mechanism.
- Wind fairing between cab and box body fabricated.
- Additional house battery for the living module connected.
- Bike rack selected and mounted.
- Cab seats replaced; centre storage box removed for easier walk-through.
- Compressed-air system with compressor and receiver for semi-air suspension adjustment and tyre inflation.